Hi Welcome to the cap info page!.
How the cap was made.. first its sculpted in air drying eproxy putty, then cast in plaster which results in a plaster mould, liquid latex is then put into the mould, when set, the cap is taken out then the rough edges trimmed with a small sciccors.
CUSTOMISING THE CAP.....
This part is up to you....... look in wrestling magazines for small enough pictures of skulls ect.. the merchandise sections are best. cut around the pic(not too close) then apply to the sticky tape,once the pic is on the tape, neatly and acuratley cut around the pic, then peel off the backing tape, then simply stick the pic on the cap. as for text, just look in any newspaper(not glossy) for white text on black backround, getting the right size, then use the same method as listed above. -----an alternative--- if you have a printer, then you need not look anywhere, just print out a scsa skull from the net, and some text. failing all that, you can always paint it on with a tooth pick, thats what i use for fine detail!. If everything goes to plan, you will end up with a cap like the ones below.....